LF JFET-INPUT OPERATIONAL AMPLIFIER. SLOSC – MARCH – REVISED OCTOBER 1. POST OFFICE BOX •DALLAS, TEXAS. LF Low Offset, Low Drift JFET Input Operational Amplifier. Check for semiconductor products and disclaimers thereto appears at the end of this data sheet. LFN. 8-Pin PDIP. mm×mm. (1) For all available packages, see the orderable addendum at the end of the data sheet. Inverting Amplifier with VOS.
|Published (Last):||25 May 2014|
|PDF File Size:||1.55 Mb|
|ePub File Size:||2.62 Mb|
|Price:||Free* [*Free Regsitration Required]|
Internally trimmed offset voltage: These devices are low cost, high speed, JFET input opera.
Input offset voltage drift: They require low supply. Low input bias current: Low input noise current: In addition, well matched high voltage JFET input.
LF is pin compatible with the standard LM allowing. Low total harmonic distortion: These amplifiers may be used in applications such as high. Fast settling time to 0.
Pin 4 connected to case. X indicates electrical grade. Y indicates temperature range. Z indicates package type. Absolute Maximum Ratings Note 1.
LF Datasheet(PDF) – TI store
Distributors for availability and specifications. Rating to be determined. Average TC of Input. Equivalent Input Noise Voltage.
Equivalent Input Noise Current. Operating Ratings indicate conditions for which the device is. Unless otherwise specified the absolute maximum negative input voltage is equal to the negative power supply voltage.
These devices are available in both the commercial temperature range 0? C and the military temperature range ? A “C” indicates the commercial temperature range and an “M”.
The military temperature range is available in “H” package only. The input bias currents are junction leakage currents which approximately double for every 10? C increase in the junction temperature, T j. In datashee operation the junction temperature rises above the ambient.
Use of a heat sink is. Supply voltage rejection ratio is measured for both supply magnitudes increasing or decreasing simultaneously in accordance with common practice, from. Power Dissipation is defined by the package characteristics. Operating the part near the Max.
Power Dissipation may cause the part to operate. Open Loop Voltage Gain. The LF is biased by a zener reference which allows.
LF Datasheet(PDF) – National Semiconductor (TI)
If the amplifier is forced to drive. Therefore, large differential input voltages can easily be. However, neither of the input voltages. Precautions should be l411 to ensure that the power supply. Exceeding the negative common-mode limit on either input. As with most amplifiers, care should be taken with lead. In neither case does a latch occur.
For example, resistors from the output to. Exceeding the positive common-mode limit on a single input. A feedback pole is created when the feedback around any. The parallel resistance and capacitance. The amplifier will operate with a common-mode input voltage.
In many instances the.
The value of the. High Speed Current Booster. TO-5 heat sinks for Q6-Q7. Metal Can Package H.
A critical component is any component of a life. Life support devices or systems are devices or. National does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and National reserves the right at any time without notice to change said circuitry and specifications.